Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Remove sanding dust.
– Spray on a thin coat of primer and allow to dry for 10 minutes.
– Apply paint finish as specified in the Audi paintwork manual.
12.5 Plastic repairs (glass fibre materials)
WARNING
Please observe all relevant safety regulations. Safety-related
components that would no longer meet functional require‐
ments after a repair (e.g. the absorption of impact energy) must
not be repaired.
1- Rupture/hole
♦ Glass fibre mat, polyester resin and hardener
2- Surface damage
♦ Glass fibre reinforced polyester resin, hardener
General InformationBody Repairs, General Body Repairs - Edition 04.2018
12. Plastic repairs 63
To Next Page
Loading...
