Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– First clean and dry the damaged panel.
– Using abrasive paper (120 grade), sand down the edges of the
hole to a funnel shape (a = 10 - 20 mm).
– Spray on a thin coat of primer and allow to dry for 10 minutes.
– Roughen the repaired surface with sandpaper (120 grade).
– Then clean the repaired area with cleaning fluid. Allow to dry
for 5 minutes.
– Spray on a thin coat of primer and allow to dry for 10 minutes.
– As the next step, bond in a reinforcing mat onto the reverse
side of the panel using adhesive so that it overlaps the dam‐
aged section by at least 20 mm.
– The hardening process can be speeded up with the aid of an
infra-red lamp. Set to 15 minutes at 60°-70°C.
– Now you can fill in the hollowed-out area on the front of the
panel using adhesive and smooth down with a scraper.
– Again, the hardening process can be speeded up on the front
of the panel with the aid of an infra-red lamp.
– Now rub down the repaired surface with sandpaper (120
grade).
General InformationBody Repairs, General Body Repairs - Edition 04.2018
62 12. Plastic repairs
To Next Page
Loading...
