Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
7.2 Rivets
Note
For information on the special tools, testers, measuring devices
and other equipment required, please refer to the Workshop Man‐
ual for the relevant vehicle or the workshop equipment catalogue.
7.2.1 Solid rivet
Opening solid rivets
– Start by making separating cuts where necessary.
– Grind off closing head and use riveting tool to press out solid
rivet.
– Detach damaged part (use a chisel if necessary).
Fitting solid rivets
– Match up new parts, apply adhesive, position new part on body
and secure in place.
– Use riveting tool to punch flanges.
Piercing and stamping are performed in one operation.
Note
Set riveting tool to material thickness for all operations. Insert
suitable clamping pins in punched holes to stop flanges coming
apart after punching.
– Insert solid rivet and use riveting tool to set closing head.
Appropriate inserts for the riveting tool are available for the vari‐
ous rivet diameters.
Note
♦
All riveted joints have to be bonded when performing repairs
in the workshop (unlike in series production). Refer to section
on bonded joints ⇒ page 31 . The solid rivet is made of alumi‐
nium.
♦
Various solid rivets are available; refer to the Workshop Man‐
ual for the relevant vehicle.
General InformationBody Repairs, General Body Repairs - Edition 04.2018
7. Cold joining techniques 33
To Next Page
Loading...
