Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
1.4 Battery, power supply
Note
Before disconnecting the battery, make sure that you have the
radio code. Before returning the vehicle to the customer, enter the
correct code so that the radio is ready for use.
Before starting welding work, always detach both battery clamps
and cover battery terminals.
Always remove the vehicle battery before performing any work
which may generate sparks in the vicinity of the battery.
WARNING
Before connecting the battery, refer to the notes for the specific
vehicle in the Workshop Manual.
⇒ Electrical system; Rep. gr. 27 ; Battery; Disconnecting and
connecting battery
1.5 High-voltage components / electric ve‐
hicles
DANGER!
Work on high-voltage components and electric vehicles may
only be performed by specially trained staff.
For further information, refer to the Workshop Manual for the
specific vehicles ⇒ Electrical system; Rep. gr. 00 ; Safety
precautions .
1.6 Natural gas vehicles
DANGER!
Work on natural gas vehicles may only be performed by spe‐
cially trained staff.
For further information, refer to the Workshop Manual for the
specific vehicles ⇒ Power unit; Rep. gr. 00 ; Natural gas en‐
gines - General information; Safety precautions .
General InformationBody Repairs, General Body Repairs - Edition 04.2018
2 1. Safety precautions
To Next Page
Loading...
