Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Note
Observe manufacturer's instructions when using materials.
12.5.1 Procedure for repairing ruptures/holes
– Grind down edge of rupture/hole all round to an angle of 45°.
– Lightly sand an area approx. 100 mm wide around the rupture/
hole (hatched area) using 150 grade abrasive paper and clean
with silicone remover.
– Cut three glass fibre mats to shape: -1- to overlap rupture/hole
by approx. 25 mm, -2- overlap approx. 50 mm, -3- overlap ap‐
prox. 75 mm.
Note
For large ruptures/holes it is recommended to use a styrene block
as a support. Cover styrene with commercially available unprinted
PE synthetic foil to prevent contact with polyester resin. Then se‐
cure the prepared support to the inside of the rupture/hole with
adhesive tape.
General InformationBody Repairs, General Body Repairs - Edition 04.2018
64 12. Plastic repairs
To Next Page
Loading...
