Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Applying glass fibre mats
– Mix polyester resin (observe manufacturer's instructions).
– Apply thin coat of polyester resin to rupture/hole.
– Soak smallest glass fibre mat -1- completely in polyester resin
and apply to rupture/hole -4-.
– After applying, remove air bubbles in polyester resin immedi‐
ately with a pointed tool.
– After applied material has hardened, sand down surface using
120 grade abrasive paper.
– Clean repaired section with silicone remover.
– Repeat work sequence for the second -2- and third -3- glass
fibre mats.
12.5.2 Procedure for repairing surface damage
– Cut damaged surface to a V shape.
– Sand area approx. 50 mm wide around damaged surface
(hatched area) using 150 grade abrasive paper.
– Clean repaired section with silicone remover.
– Mix glass fibre reinforced polyester resin (observe manufac‐
turer's instructions) and apply to repaired section (hatched
area).
– After applied material has hardened, sand down repaired sec‐
tion and clean with silicone remover.
General InformationBody Repairs, General Body Repairs - Edition 04.2018
12. Plastic repairs 65
To Next Page
Loading...
