98 On the road
Changing speed
• Press the lever in the direction of the 0
~
page 97, fig. 109 or in the direction of the
0 to increase or decrease your speed.
• Let go of the lever to save that speed.
Change speed in increments of 1 mph (1 km/
h) by lightly pressing the lever.
If you keep the
lever pressed down, you will alter your speed
in 5 mph (10 km/h) increments.
You can also press the accelerator pedal down
to increase your speed, e.g. if you want to
pass someone. The speed you saved earlier
will resume as soon as you let off of the accel-
erator pedal.
If, however, you exceed your saved speed by
S mph (10 km/h) for longer than S minutes,
the cruise control will be turned off tempora-
rily. The green symbol in the display turns
white, the saved speed is retained.
Pre-selecting speed
You con pre-select your desired speed while
the vehicle is not moving .
• Turn on the ignition.
• Pull lever into position
(D ¢ page 97,
fig. 109.
• Press the lever in the 0 or 0 direction to
increase or decrease your speed.
• Let go of the lever to save that speed .
This function makes it possible, for example,
to save the speed you want before driving on
the highway. Once on the highway, activate
the cruise control by pulling the lever toward
(D.
Switching off
Temporary deactivation
• Step on the brake pedal, or
• Press the lever into position @ (not clicked
into place) ~ page 97, fig. 109, or
• Drive for longer than S minutes at more
than S mph (10 km/h) above the stored
speed.
Switching off completely
• Press lever into position @ (clicked into
place), or
• Switch the ignition off.
The speed you saved will be retained if the
cruise control has been switched off tempora-
rily. To resume the saved speed, let up on the
brake and pull the lever to position
(I) .
The saved speed will be erased after turning
the ignition off.
& WARNING
~
You should only resume the saved speed if
it is not too high for existing traffic condi-
tions. Otherwise you risk an accident.
To Next Page
Loading...
