6 6 Seat s an d s t o ra ge
unattended in the vehicle - they could be
injured!
- Exercise caution when adjusting the seat
height. Unsupervised or careless seat ad-
justment can pinch fingers or hands
causing injuries.
- While the vehicle is moving, the seat-
backs of the front seats must not be in-
clined too far to the rear because the ef-
fectiveness of the safety belts and the
airbag system is severely comprom ised -
there is a risk of injury.
- To reduce the risk of injury in the case of
sudden braking or accident, front pas-
sengers must never ride in a moving ve-
hicle with the seatback reclined . Safety
belts and the airbag system only offer
maximum protection when the seatback
is upright and the safety belts are prop-
erly posit ioned on the body. The more
the seatback is reclined, the greater the
risk of personal injury from an incorrect
seating posit ion and improperly posi-
tioned safety belts .
Seat memory
Memory for driver's seat
Applies to vehicles: with seat memo ry
The seat adjustment settings for two drivers
can be stored using the memory buttons in
the driver's door.
Fig. 66 Driver's door : Seat me mory
In addition to the setting for the driver's seat,
the exterior rear view mirror setting can be
stored and recalled through seat memory if
the vehicle is properly equipped .
Storing and recalling setting s
With the help of the memory buttons 1 and 2
¢ fig. 66 the settings for two different drivers
can be stored and recalled
¢ page 66.
The current sett ings are also automatica lly as-
signed to t he remote control key being used
when the vehicle is locked. When the vehicle
is unlocked, the settings assigned to the re-
mote control key being used are automatically
recalled.
Turning seat memory on and off
If t he I O FF I switch is depressed, the seat
memory is inoperative. When the Memory
function is off, the LED in the button lights up.
All the stored settings are retained. We rec-
ommend using the
!O FF ! switch and deactivat -
ing the seat memory if the vehicle is only go-
ing to be used
temporarily by a driver whose
settings are not going to be stored.
Storing and recalling settings
Applies to vehicles: wit h seat memory
Storing sett ings
.,. Adjust the driver's seat.
.,. Adjust the two exterior mirrors .
.,. Press the
ISETI button . The light in the but-
ton will come on.
.,. Now press a memory button
<ill or ill). If
the storing procedure is correct, a confirma-
tion tone w ill sound.
Recalling setting s
.,. If the driver's door is open, tap the corre-
sponding memory button briefly .
.,. If the driver's door is closed, press the ap-
propriate memory button until the stored
position is reached.
Successful storage is confirmed audibly and
by the light in the
ISETI button illum inating
¢ page 66, fig. 66 .
When the vehicle is locked, the current set-
tings are stored and assigned to the remote
control key. But the settings sto red on memo-
ry buttons 1 to 2 are not deleted. They can be .,,.
To Next Page
Loading...
