62 Clear v ision
Digital compass
Activating or deactivating the compass
Applies to vehicles: with digital compass
The direction is displayed on the interior rear
view mirror .
Fig. 63 Ins ide rear view mirror: digital compass acti -
vated
.. To activate or deactivate, hold the @ button
down until the red disp lay appears or disap-
pears.
The digital compass only works with the igni-
tion turned on. The directions are displayed as
initials:
N (North), NE (Northeast), E (East),
SE (Southeast), S (South), SW (Southwest),
W (West), NW (Northwest).
(0 Tips
To avoid inaccurate directions, do not al-
low any remote controls, electrical sys-
tems, or metal parts close to the mirror.
Setting the magnetic deflection zone
Applies to vehicles: with dig ital compass
The correct magnetic deflection zone must be
set in order to display the directions correctly.
Fig. 64 Nort h America: magnet ic deflect ion zone
boundar ies
.. Hold the @ ¢ page 62, fig. 63 button down
until the number of the set magnetic deflec -
tion zone appears on the interior rear view
mirror.
.. Adjust the magnetic deflection zone by re-
peated ly pressing on the @ button. The set
mode automatically deact ivates after a few
seconds.
Calibrating the compass
Applies to veh icles: with dig ital compass
The compass has to be recalibrated if the dis-
play is wrong or inaccurate .
.. Hold the @ button down unt il the letter
C is
displayed on the interior rear view mirror .
.. Drive in a circle at a speed of about S mph
(10 km/h) until a direct ion is shown on the
interior rear view mirror.