128 Automatic transmission
Automatic transmission malfunction
[O] Transmission: please press the brake ped-
al and select the position again
Press the brake pedal and select the desired
selector lever posit ion again . You can then
continue dr iving .
[O] Transmission hot: please modify driving
style
The transmission temperature has increased
significantly due to the sporty driving manner.
Drive in a less sporty man ner until the tem-
perature returns to the normal range and the
indicator light switches of.
[O] Transmission malfunction: You can con-
tinue driving
There is a system malf unction in the transmis-
sion. You may continue driving. Drive to your
authorized Audi dealer or qualified repair fa-
cility soon to have the malfunction corrected .
[O] Transmission malfunction: Limited driv-
ing functionality
There is a system malf unction in the transmis-
sion. The transmission is switching to emer-
gency mode. This mode only shifts into cer-
tain gears or will no longer shift at all. The en-
gine may stall. Drive to your authorized Audi
dealer or qualified repair facility immediately
to have the malfunction corrected.
[O] Transmission malfunction: Stop and shift
to P
Do not continue driving . Select the P selector
lever position and see your authorized Audi
dealer or qualified repair facility for assis-
tance.
(D Note
If the transmiss ion switches to emergency
mode, you should take the vehicle to an
author ized Audi dealersh ip as soon as pos-
sible to have the condition corrected.
Emergency release of the selector lever
If the vehicle 's power supply fails, the selec-
tor lever can be released in an emergency.
Fig. 149 Removing as htray insert
Fig. 150 Emerge ncy relea se for selecto r lever
The emergency release is located under the in-
sert for the ashtray.
"' Slide open the cover for the ashtray.
"' Release the ashtray by pushing the switch
@ ¢ fig. 149 t o the right.
"' Remove the ashtray insert @ .
"' Now you can see a small cover in the asht ray
holder on the front of the ashtray recess
¢fig . 150.
"' Release and remove this cover.
"' You now have access to a bolt. Using a
screwdriver or similar, press the bolt down
and hold it down .
"' Now press the interlock and move the selec-
tor lever to the N posit ion.
The selector lever can only be moved from the
P position if the igniti on key is in the lock and
the ignit ion is turned on. If the vehicle has to
be pushed or towed if the power supply fails
(e.g. battery is discharged), the selector lever
must f irst be moved to the N posit ion using
the emergency locking device.
To Next Page
Loading...
