M
"'
0
..J
"".
rl
I.O
"'
rl
"'
rl
a short t ime in the Information line
¢ page 124.
@ Tips
For safety reasons, the stored speed is
erased when the ignition or the ACC is
turned off.
Changing stored speed
Applies to vehicles : with adapt ive cruise control
The speed can be changed without touching
the accelerator or brake p edal.
Fig. 133 Contro l lever: Changing speed
Inc reasing speed
• Press the leve r briefly upw ards 0
9 fig. 133. USA models: the speed increases
by about 2.5 mph . Canada models : s peed
will increase by one mark on the speedome -
ter sca le.
• Press the lever upwards
0 and hold it . As
long as you ho ld the control switc h down,
the light diode display in t he speedome t er
LED display in the speedometer moves for-
ward and the speed is increased.
Reducing speed
• Press the lever briefly downwards Q . USA
models: the speed decreases by 2.5 mph .
Canada models: speed will decrease by one
mark on the speedometer scale.
• Press the lever downwards
O and hold it.
As long as you hold the control sw itch down,
the light diode display in the speedometer
LED display moves ba ckward and the speed
is reduced .
After releasing the control switch, the system
regulates the speed to the value just set.
Ad a pti v e crui se control 119
After each adjustment, the newly-set speed is
shown for a short time in the Information line
9 page 124 .
_& WARNING
Improper use of the adaptive cruise con-
trol features and inattent ion can lead to an
accident causing ser ious personal injury.
- It is dangerous to use the "RESUME" fea-
ture when the prev iously set speed is too
high for existing road, traff ic or weather
conditions.
- Always read and heed the information
and WARNINGS
¢ .&.in Description on
page 115 .
(D Tips
You can increase your speed at any time by
stepp ing on the accelerato r pedal. After
you release t he acce lerator pedal, the sys-
tem adjusts back down to the speed you
previously set . A new desired speed can be
stored at any time by press ing the
!SETI
button 9page 118, fig. 132 .
-
To Next Page
Loading...
