M
N
0
...J
'SI:
,....,
\!)
..,.,
,....,
..,.,
,....,
Adjusting the display
and warning tones
Applies to vehicles: with rear park assist/Audi parking sys-
tem plus with rearview camera/front- and rearview cam-
era
The display* and warning tones can be ad-
justed in the MMI.
~
Select: ICARI function button> Systems*
control button > Parking system. Or
~
Select: ICARI function button> Car systems*
control button > Driver assist> Parking aid.
Display*
- Off - when the parking system is switched
on, only audible signals are given.
- On - when the parking system is switched
on, either the visua l display or the picture
from the rearview camera is disp layed.
Warning tones
- Front volume* - front sensor volume
- Front frequency* - front sensor frequency
- Rear volume - rear sensor volume
- Rear frequency - rear sensor frequency
- In-car entertainment fader/ Music volume
while parking - when the parking system is
switched on, the volume of the active audio
source is lowered.
The newly adjusted value is briefly heard from
the signal generator .
(D Tips
- The warning tones can also be adjusted
direct ly by the visual disp lay* or the pic-
ture from the camera*. Simply press the
Settings* contro l button.
- Changed settings are activated when
parking system is switched on again.
- The settings are automatically stored
and assigned to the remote control key
being used.
Parking
systems 155
Error messages
Applies to vehicles: with rear park assist/Audi parking sys-
tem plus with rearview camera/front- and rearview cam-
era
There is an error in the system if the LED in
the~ button* is blinking and you hear a con-
tinuous alarm for a few seconds after switch-
ing on the park ing system or when the park-
ing system is already activated .
If the error is
not corrected before you switch off the igni-
tion, when you switch on the parking system
again, the LED in the ~ button* will blink. If
you activate the parking system with the but-
ton in this case, the continuous warning tone
will continue to sound.
Parking system plus with front and
rearview camera*
There is another system error if:
- the~·· symbol appears in the display and
the corresponding display area is shown in
blue. The camera is not working in this area.
- all segments around the vehicles are red or
if no segments are displayed.
Drive to your authorized Audi dealer or au-
thorized repair facility immed iately to have
the malfunction corrected .
Trailer hitch
Applies to vehicles: with rear park assist/Audi parking sys-
tem plus with rearview camera/front- and rearview cam-
era and trailer hitch
For vehicles using the trailer socket, the park-
ing system rear sensors do not turn on when
you shift into reverse gear or when you press
the~ button*. This results in the follow ing
restrictions:
Rear park assist*
There is no warning for distances to the rear.
Audi parking system plus with rearview
camera/front and rearview camera*
There is no distance warning for the rear. The
front sensors remain activated. The visual dis-
play switches to the trailer towing mode. The
rearview camera image will not show the ori-
entat ion lines and the blue surfaces . ..,.
To Next Page
Loading...
Need help?
General
