76 Seats and storage
unattended in the vehicle - they could be
injured!
- Exercise caution when adjusting the seat
height. Unsupervised or careless seat ad-
justment can pinch fingers or hands
causing injuries.
- While the vehicle is moving, the seat-
backs of the front seats must not be in-
clined too far to the rear because the ef-
fectiveness of the safety belts and the
airbag system is severely compromised -
there is a risk of injury .
- To reduce the risk of injury in the case of
sudden braking or accident, front pas-
sengers must never ride in a moving ve-
hicle with the seatback reclined . Safety
belts and the airbag system only offer
maximum protection when the seatback
is upright and the safety belts are prop-
erly positioned on the body. The more
the seatback is reclined, the greater the
risk of personal injury from an incorrect
seating position and improperly posi-
tioned safety belts.
Seat memory
Driver's seat memory
Applies to vehicles: with sea t memo ry
The seat adjustment settings for two drivers
can be stored using the memory buttons in
the driver's door.
Fig. 78 Driver's door : Seat memory
In addition to the setting for the driver's seat,
the settings for the steering colum n* and
both exterior mirrors can be stored .
Storing and recalling settings
Using the memory buttons 1 and 2, you can
store and recall the settings for two different
drivers¢
fig. 78.
The current settings are also automatically as-
signed to the remote control key being used
when the vehicle is locked. When the vehicle
is unlocked, the settings assigned to the re-
mote control key being used are automatically
recalled. This function has to be activated in
the MMI ¢
page 77, Activating remote con-
trol key memory.
Turning seat memory on and off
If the I ON/OFF I switch is depressed, the seat
memory is inoperative. The word
OFF next to
the
ION/OFF ! switch illuminates.
All the stored settings are retained. We rec-
ommend using the
ION/OFF I switch and deac-
tivating the seat memory if the vehicle is only
going to be used
temporarily by a driver
whose settings are not going to be stored.
Storing and recalling a seat position
Applies to vehicles: with seat memory
Before you can store or recall your seat posi-
tion, the
ION/OFF I button must be engaged
(down) .
Storing settings
.,. Adjust the driver's seat ¢ page 75 .
.,. Adjust the steering column* ¢ page 105 .
.,. Adjust both outside mirrors ¢ page 70. In
the tilt-down position, the passenger mirror
can be adjusted to the preferred position
and saved in the seat memory .
.,. Press the
ISE T I button and hold it down. At
the same time, press one of the memory
buttons for at least one second .
.,. Release the buttons. The settings are now
stored under the corresponding memory
button.
Recalling settings
.,. If the driver's door is open and the ignition
is switched off, press the desired memory
button.
...
To Next Page
Loading...
Need help?
General
