30 Dr iver in f ormation d ispl ay
(30 km/h to 240 km/h) . Settings can each be
adj usted in intervals of S mph (10 km/h) .
Auto Check Control
Introduction
The Auto-Check control monitors the function
of certai n veh icle featu res and components . It
simply makes sure these features and compo-
nents are work ing proper ly. The Auto -Check
contro l wo rks as long as the ignition is on, as
well as whenever the vehicle is driven.
If a componen t is ma lfunctioning or if t he
need for an urgent repair has been detected,
this will appear in the instrument cluster dis-
play. You will a lso hear an audible warn ing
tone . The displays are color coded in either
red or yellow depending on their level of prior-
ity.
A red symbo l means
Danger, a ye llow symbo l
indic ates
Warning . In certain situations, in-
formation message for the dr iver appear in
addit ion to the red and yellow symbols.
Function te st : automat ic transmi ssion
The Auto -Check Control will automat ica lly
perform a test each time you switch on the ig-
nition. With the selector lever in P or N, the
following message appears in the display :
When station ary apply brake pedal while se-
lecting gear
When you select a different gear (for exam -
ple: R, D, etc.), the message will d isappear
and the Auto-Check function is d isplayed .
If the re is a malf unction, t hen the malfunc-
tion message will appear about 15 seconds af-
ter the you start t he vehicle. At t he same time
you will hear a warning tone .
Driver information messages
Driver information messages are shown in the
instrument cluster display in addition to the
red and yellow symbols .
Fig. 24 Ins tr ume nt clust er: CHECK butto n
For example, if the transmiss ion selec to r lever
is not in the P position when the engine is
turned off, the following message appears :
Shift to P otherwi se vehicle can roll away.
Doors do not lock if you are not in P.
The ignition key can only be removed with the
selector in this position . This and other mes-
sages are bro ugh t up if a func t ion cannot be
carr ied out.
Driver messages and red symbols
If a red symbol appea rs in the display, a d river
message can be shown by pressing the
I CH ECK I button.
For example, the symbo l for a problem with
engine oil pressure . appears in the d isp lay.
If you then press the
I CHECK I button , the fol-
lowing dr iver mess age appears in the display:
Switch off engine ! Oil pressure too low
The driver message in the display goes out af-
ter about 5 seconds . The driver message can
be displayed again by briefly press ing the
I CH ECKi button.
Driver messages and yellow symbol s
If a yellow symbol appears in the display, a
driver message is also displayed automatical-
~
~
To Next Page
Loading...
Need help?
General
