M
"'
0
..J
"".
rl
I.O
"'
rl
"'
rl
Loading the vehicle onto a flat bed truck
Fig. 278 Vehicle on fla t bed tr uck
Front hook up
.. Align the vehicle with t he centerline of the
car carr ier ramp.
.. Attach the winch hook to the front towline
eye previously installed .
Rear hook up
.. Align the vehicle with the centerline of the
car carrier ramp.
.. Attach the winch hook to the rear towline
eye previously installed.
(D} Tips
Check carefully to make sure the hook- up
is secure before moving the car up the flat-
bed truck ramp .
Lifting vehicle
Lifting with workshop hoist and with
floor jack
The vehicle may only be li~ed at the lifting
points illustrated .
Fig. 279 Front lift ing point
Emergenc y s itu ation s 321
Fig. 280 Rear liftin g point
.,. Read and heed WARNING c::> .&,.
.,. Locate lifting points c::> fig. 2 79 and
¢ fig. 280 .
.,. Adjust lifting arms of wo rkshop ho ist or
floor jack t o ma tch veh icle lifting points.
.. Insert a rubbe r pad bet ween the floor jack/
workshop hoist and the lift ing points.
If you mus t lift your veh icle with a floor jack
to work underneath, be sure the vehicle is
safel y supported on stand s intended for thi s
purpose .
Front lifting point
The lifti ng point is locat ed o n the floo r pan re-
inforcemen t abo ut at the same level as the
jack mounting point
c::>fig. 279. Do not lift
the vehicle at the vertical sill reinforcement.
Rear lifting point
The lifting point is located on the vert ica l rein-
fo rcement of t he lower sill for t he on board
jack
c::> fig. 280 .
Lifting with vehicle jack
Refer to c:;, page 309 .
A WARNING
- To reduce the risk of ser ious injury and
veh icle damage.
- Always lift the vehicle only at the spe-
cia l workshop hoist and floor jack lift
points illustrated
c:;, fig. 279 and
c:;, fig. 280.
- Failure to lift the veh icle at these
-
po ints could cause the vehicle to tilt or ..,.
To Next Page
Loading...
