CD
CD
....
N
"
N
....
0
0
"' 'SI'
The threaded opening for the towing loop is lo-
cated behind a cover on the right side of the front
bumper .
.., Remove the tow ing loop from the veh icle tool
kit
¢ page 262 .
... Press inward on the upper left side of the cap
to remove it from the bumper ¢
fig. 188 .
.., Tighten the towing loop in the threaded open -
ing until it stops ¢ fig . 189 and then tighten it
with a wheel wrench .
.., After using, place the towing loop back in the
vehicle tool kit.
& WARNING
If the towing loop is not tightened unti l it
stops when installing, the threads may be
pulled out when towing the vehicle and that
could cause an accident.
-
Loading the vehicle onto a flat bed truck
Fig. 190 Vehicle on flat bed truck
Front hook up
... Align the vehicle with the centerline of the car
earner ramp .
.., Attach the winch hook to the front towline eye
previously installed.
@ Tips
Check carefully to make sure the hook-up is
secure befo re moving the car up the flatbed
truck ramp .
Emergency situations
275
To Next Page
Loading...
