11
Rev.1.25
[13] [AUDIO IN] External input terminal (side)
Transmits the audio from a connected external device to the receiver.
When an external device is connected to this terminal, audio from the [1] microphone opening and
[6] microphone input terminal is muted.
[14] E2 Button (both sides)
Press and hold both side E2 buttons simultaneously for 2 seconds or more to activate the E2
output (alert).
A signal is sent from the E2 contact of a receiver. (This alert can also be sent when the microphone
is off.)
In order to release the Microphone from its E2 state, restart the microphone. Press and hold
PWR/MUTE 2 seconds or more to turn it off. Press the PWR/MUTE button one more time to turn
on the power again.
Note: This will not release the E2 state on the receiver right away. To release the receiver’s E2
state, please read the instruction manual for the receiver (K-SRC14).
During an E2 state, all button operations are not possible, except for power OFF.
When sending an alert out of range of a receiver, the alert will wait to send until connection is
possible. (Refer to K-SRC14 manual: Alert message and sound at E2)
[15] Neck strap
Allows users to wear the microphone around the neck.
[16] Clip (rear)
Allows user to adjust the neck strap to an appropriate length. The clip can attach to the user’s
clothes as well.
[17] Battery cover (rear)
The battery cover can be removed by pushing down and pulling in the direction of the arrow.
[18] Battery slot (inside the battery cover)
Install one lithium-ion rechargeable battery, paying attention to the charging terminal inside the
battery cover.
To Next Page
Loading...
