23
Rev.1.25
Replacing the neck strap
• When replacing the neck strap, turn off the power of the microphone, and make sure that the
microphone is not connected to the charger.
Remove the neck strap from the microphone.
1) Using a screwdriver, remove the back screw
on the microphone’s clip.
2) Remove the other side of the neck strap.
When attaching a neck strap to the
microphone, hook each side of the
strap to each claw, and reverse the
above procedure.
After the neck strap is attached to the microphone,
make sure both sides of the neck strap are hooked to
the claws.
Important:
• Use only the neck strap that is intended for this microphone.
(This neck strap is provided with a safety closure to prevent strangling.)
Otherwise, that may result in accidental injury.
To Next Page
Loading...
