9
Preparation for use
Installing/removing the dust cover
• The dust cover is designed to protect the product’s sensitive
components when the product is not in use. It should remain off
while records are playing.
• Using the dust cover during play may result in record damage or
sound degradation.
• Always remove and replace the dust cover carefully.
Connecting to connectable equipment (active
speakers, amplifiers, etc.)
Connect the RCA audio cable to an input jack that is compatible with
the connectable equipment you are using (amplifier, receiver, active
speakers, sound card, etc.).
• The RCA audio cable’s red jack is for the right (R) channel, and the
white jack is for the left (L) channel.
* Depending on the equipment you are connecting, a ground (earth)
terminal may exist near the phono input jack. If this is the case,
connect to it using the ground line from the RCA audio cable. This
will help prevent a low humming noise that might otherwise be heard
during playback.
Connecting the power cable
Finally, after all audio connections are made, attach the included
power cable to the product. Then connect the power cable plug to a
convenient AC outlet.
PHONO
L R
With PHONO input*
To outlet
To outlet
Connectable
equipment
(amplifier, etc.)
To Next Page
Loading...
Need help?
General
Weight and Dimensions
