EasyManuals Logo

Audio Technica AT-LP140XP User Manual

Audio Technica AT-LP140XP
35 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #21 background imageLoading...
Page #21 background image
2
Safety precautions
Although this product was designed to be used safely, failing to use
it correctly may result in an accident. To ensure safety, observe all
warnings and cautions while using the product.
Important information
Warning:
To prevent fire or shock hazard, do not expose this apparatus to rain or
moisture.
Caution:
Do not expose this apparatus to drips or splashes.
To avoid electric shock, do not open the cabinet.
Refer servicing to qualified personnel only.
Do not expose this apparatus to excessive heat such as sunshine, fire
or the like.
Do not subject this apparatus to strong impact.
This apparatus should be located close enough to the AC outlet so
that you can easily grasp the AC adapter at any time.
In case of emergency, disconnect the AC adapter quickly.
Do not place any objects filled with liquids, such as vases, on this
apparatus.
To prevent fire, do not place any naked flame sources (such as
lighted candles) on this apparatus.
Do not install this apparatus in a confined space such as a bookcase
or similar unit.
Install this apparatus only in the place where ventilation is good.
The rating label is put on the bottom of this apparatus.
For customers in the USA
FCC Notice
Warning:
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Caution:
You are cautioned that any changes or modifications not expressly
approved in this manual could void your authority to operate this
equipment.
Note: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Safety precautions
For customers in Canada
IC statement:
CAN ICES-3 (B)/NMB-3(B)
Notes on use
Turntable body
Do not set and use the product in locations that are considerably hot
or humid, dirty, or subject to extreme vibrations.
The product should be positioned on a flat, level surface.
Cartridge
Attach the protector to protect the stylus when the product is not in
use.
Do not touch the stylus of the cartridge with your finger.
Do not allow the cartridge's stylus to bump against the platter or the
edge of the record.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Audio Technica AT-LP140XP and is the answer not in the manual?

Audio Technica AT-LP140XP Specifications

General IconGeneral
TypeDirect drive DJ turntable
OperationManual
Motor typeDC motor
Brake systemElectronic brake
Pitch controlYes
Wow & flutter0.2 %
Nominal speeds33 1/3, 45, 78 RPM
Starting torque2.2 kg/cm
Motor brush typeBrushless
Number of speeds3
Pitch control range-8 - 16 %
Signal-to-Noise Ratio (SNR)50 dB
Product colorSilver
Platter materialAluminum
USB port-
AC input voltage115 - 230 V
AC input frequency50 - 60 Hz
Power consumption (typical)4.3 W
ShapeS-shaped tonearm
Overhang16 mm
Tonearm typeStatically balanced tonearm
Tracking angle3 °
Stylus pressure6.2 g
Anti-skating range0 - 4 g
Cables includedRCA/GND
Weight and Dimensions IconWeight and Dimensions
Weight10000 g

Related product manuals