9
Connecting via Bluetooth
Pairing a Bluetooth device
• Read the user manual for the Bluetooth device.
• Place the Bluetooth device within 1 m (3.3') of the product to perform pairing
correctly.
• To confirm the progress of the pairing process, wear the product while performing this
procedure and listen for the confirmation tone.
1. Remove the headphones (L (left) and R (right)) from the charging case.
• The indicator lamps will flash in white.
2. Use your Bluetooth device to begin the pairing process and search for the product.
When your Bluetooth device finds the product, “ATH-CKR7TW” will be displayed on the device.
• For information about using your Bluetooth device, refer to the device’s user manual.
• This product may be displayed as "ATH-CKR7TW", "BLE_ATH-CKR7TW", or both. If both are displayed, select
"ATH-CKR7TW". If only one is displayed, select that one.
3. Select “ATH-CKR7TW” to pair the product and your Bluetooth device.
• Some devices may ask for a passkey.
In this case, enter “0000”. The passkey may also be called a passcode,
PIN code, PIN number, or password.
• The product sounds a confirmation tone when pairing is complete.
About pairing
When connecting a new Bluetooth device, you need to pair it with the product. Once the Bluetooth device and the
product are paired, you do not need to pair them again.
However, in the following cases you will need to pair again even if the Bluetooth device was paired once:
• If the product is deleted from the Bluetooth device’s connection history.
• If the product is sent out for repair.
• If 8 or more devices are paired.
(This product can save the pairing information of up to 8 devices. When you pair with a new device after pairing with
7 devices, pairing information for the device with the oldest connection date will be overwritten by the information for
the new device.)
• When switching to a Bluetooth device, you may not be able
to pair because the previously connected Bluetooth device
cannot be disconnected. In such cases, place the headphones
into the charging case (with battery level remaining for the
case) and press and hold (about 4 seconds) the multifunction
button on the R (right) side. The product will switch to the
“searching for devices” state and you will be able to pair with
your desired Bluetooth device.
To connect the product to a Bluetooth device, the product needs to pair (register) with the device.
100%12:00
Bluetooth ON
ATH-CKR7TW
To Next Page
Loading...
Need help?
General
Weight and Dimensions
