Session Border Controllers 11 Mediant 500 E-SBC
Hardware Installation Manual 1. Introduction
1 Introduction
This document provides a hardware description of the Mediant 500 E-SBC (hereafter
referred to as device) and step-by-step procedures for mounting and cabling the device.
The device supports the following interfaces:
Four Gigabit Ethernet (10/100/1000Base-T) LAN ports
Single E1/T1 port interface over a single copper wire pair (PRI interface is a customer-
ordered item
Two USB ports for optional, USB storage services
Serial console port (RJ-45) for device management
Notes:
• Hardware configurations may change without notice. Currently available hardware
configurations are listed in AudioCodes Price Book. For further enquiries, please
contact your AudioCodes sales representative.
• For information on configuring the device, refer to the device's User’s Manual.
To Next Page
Loading...
