AudioCodes Mediant 500 - Connecting a USB Storage Device; Figure 5-7: Connecting a USB Storage Device

Session Border Controllers 27 Mediant 500 E-SBC
Hardware Installation Manual 5. Cabling the Device
5.5 Connecting a USB Storage Device
The device supports USB storage capabilities, using an external USB hard drive or flash
disk (disk on key) connected to the device's USB port. The storage capabilities are
configured through CLI and include the following:

Saving network captures to the USB

Updating the device's firmware from the USB

Updating the device's configuration from the USB

Saving the current configuration to the USB
 To connect the USB storage device:

Connect the USB storage device to one of the USB ports located on the front panel.
Figure 5-7: Connecting a USB Storage Device
Note: Only a single USB storage (formatted to FAT/FAT32) operation is supported at any
given time.