AudioCodes Mediant 500L MSBR - Rear Panel Description; Table 3-9: Front Panel Description

MSBR Series 19 Mediant 500L MSBR
Hardware Installation Manual 3. Physical Description
3.3 Rear Panel Description
The device's rear panel is shown in the figure below and described in the subsequent table.
Note: The figure above is used only as an example. The hardware configuration
depends on the ordered model.
Table 3-9: Front Panel Description
Item # Label Description
1
POWER
12V -- 5A
AC power supply plug entry for connecting the device to the external
AC power supply adapter.
2 ON / OFF Power button which powers on the device when pressed in and
powers off the device when pressed again (pressed out).
3
CONSOLE
RJ-45 port for RS-232 serial communication with the device.
4 USB 2.0 port, which can be used for the following:
 3G cellular WAN modem for primary or backup WAN
 External USB hard drive or flash disk (disk on key) for USB
storage capabilities (for example, for configuration file)
5 // Reset pinhole button for resetting the device or for restoring it to
factory defaults. To restore the device to factory defaults, do the
following:
With a paper clip or any other similar pointed object, press and hold
down the pinhole button for at least 12 seconds, but no longer
than 25 seconds
6
WAN
WAN interface ports, which can be any of the following (depending
on ordered configuration):
 GE: Copper GE
 GE SFP: SFP module - dual-mode supporting 1.25 Gbps
 V/ADSLoPOTS: ADSL/2+ and VDSL2
Note: For available WAN configurations, contact your AudioCodes