Version 5.2/5.4 79 January 2009
Troubleshooting Guide 14. Management Utilities
The device to which you want to assign an IP address and load the software files is defined
in the BootP/TFTP Server utility's 'Client Configuration' dialog box, as shown below. The
device is defined by MAC address. Ensure that the 'Flash Burn' check box is selected in
order to save the loaded firmware file (cmp) to the device's flash memory; otherwise, the
cmp file is only stored in the volatile memory (RAM) and after a device reset, the device will
revert to the previous software version.
Figure 14-2: Defining Device
To Next Page
Loading...
