AudioCodes MediaPack MP-114 Hardware Installation Manual

Analog Gateways 25 MP-11x
Hardware Installation Manual 5. Cabling MP-11x
5.2 Connecting MP-11x to the Ethernet Network
The procedure below describes how to connect MP-11x directly to the Ethernet network.
Cable specifications:

Cable: Crossover Ethernet cable

Connector: RJ-45

Connector Pinouts:
Figure 5-2: RJ-45 Connector Pinouts for Ethernet Connection
 To connect MP-11x directly to the Ethernet network:
1. Connect one end of a crossover RJ-45 Ethernet cable to the Ethernet port (labeled
Ethernet).
Figure 5-3: Connecting to the Ethernet
2. Connect the other end of the cable to the network.

AudioCodes MediaPack MP-114 Specifications

General

Model	MP-114
Category	Gateway
Analog Ports	4 FXS
Network Interfaces	2 x 10/100Base-T Ethernet
Voice Codecs	G.711, G.726, G.723.1, G.729A/B
Fax Support	T.38
Management	Web-based management, CLI, SNMP
Security	SRTP, TLS, HTTPS
Ports	4 RJ-11, 2 RJ-45
Protocols	SIP, H.323
Operating Temperature	0°C to 40°C
Storage Temperature	-20°C to 70°C
Humidity	10% to 90%, non-condensing