Version 6.0 35 March 2010
Installation Manual 3. Configuring the Device
3 Configuring the Device
This section describes initial, basic setup configuration for the device, using the device's
embedded Web server (Web interface
).
Notes:
• The device is supplied with application software (cmp file) already
residing on its flash memory. This software is set to factory defaults.
• If necessary, you can restore the device to factory defaults (refer to
'Restoring Factory Default Settings' 48 on page ).
3.1 Assigning an IP Address
This section describes how to change the device's default IP address so that it corresponds
with your network environment.
Table 3-1: Default IP Addresses
The table below lists the device's default IP address.
Parameter Default Value
IP Address
FXS and FXS / FXO devices: 10.1.10.10
FXO device: 10.1.10.11
Note: FXO interfaces are applicable only to MP-11x series
devices.
255.255.0.0
Subnet Mask
0.0.0.0
Default Gateway IP Address
To assign an IP address to the device, use one of the following methods:
Device's HTTP-based embedded Web server `accessed using a Web browser (refer to
'
Assigning an IP Address Using HTTP' 36 on page ).
BootP (refer to 'Assigning an IP Address Using BootP' 37 on page ).
Embedded Command Line Interface (CLI), accessed using RS-232 or Telnet (refer to
'
Voice Menu using a standard touch-tone telephone connected to one of the FXS
analog ports (refer to ‘Assigning an IP Address Using the Voice Menu Guidance’ on
page 38).
Assigning an IP Address Using the CLI' 40 on page ).
Dynamic Host Control Protocol (DHCP) - refer to the User's Manual
.
Tip:
If at a later stage after re-defining the IP address, your IP address is unknown
(e.g., forgotten), use the BootP/TFTP utility to access the device (refer to the
Product Reference Manual).
To Next Page
Loading...
Need help?
General
