4: Remote Handset
Page 4
NOTE : the handset buttons shown crossed out are for use with other Audiolab units like
Audiolab 6000CDT and are not operational when used with the 6000A
Fitting Batteries
Always use AAA batteries and replace them in sets -
never mix old and new batteries.
Very weak batteries can leak and damage the handset.
Replace them in good time!
Note: there is a risk of fire and burns if a battery
is handled improperly. Do not disassemble, crush,
puncture, short the contacts or dispose of the batteries
in fire or water.
Do not attempt to open or service a battery. Discard used
batteries in full accordance with recycling regulations in force
in your area.
Handset Operation
The handset operates several Audiolab components.
The handset buttons shown crossed out are for use
with other Audiolab units and are not operational when
used with the 6000A.
Point the handset at the remote receiver and press the
relevant key. The handset should be within 15 meters
of the player and there must be a clear line of sight
between the two units.
1 STANDBY Press to bring the unit in/out of Standby
2 VOL+ Increase Volume
3 VOL- Decrease Volume
4 DISPLAY Press to toggle the display on/off
5 A Press to select 6000A remote mode
6 CD Press to select 6000CDT remote mode
7 SOURCE Press to cycle source inputs
8 MODE Press to select 6000A operating mode
9 MUTE Press to mute and unmute the sound
10 MENU Press to enter MENU
11
Press once to replay the current track of BT
Move to previous page or setting in menu
12
Press to start / pause BT playback
Press to confirm page or setting selected in
menu
13
Move to the next track of BT
Move to next page or setting in menu
Important Safety
Information
Getting Started
Controls and Connectors
Remote Handset Connections Operation Warranty Coverage Specifications
To Next Page
Loading...
Need help?
General
