Page 7
6: Operation - 2
Pre-Power mode
The pre-amplifier section is internally disconnected from the power amplifier. The
6000A can be used as a stand alone power amplifier (ie. part of an AV setup). This
mode can also be used if additional signal processing is required, connecting the Pre-
out to an external signal processor and then take the output from the processor to
the 6000A Power-IN.
Operating Modes
Although the 6000A is an integrated amplifier it can function as a separate
Pre and Power amplifier.
Use the MODE knob on the front panel, or the MODE key on the Remote
control, to select different operating modes.
MODE POWER AMP IN PRE OUT HEADPHONE OUT LOUDSPEAKERS
PRE DISABLE ACTIVE ACTIVE DISABLE
PRE-POWER ACTIVE ACTIVE ACTIVE ACTIVE
INTEGRATED DISABLE ACTIVE ACTIVE ACTIVE
Pre Mode
All signals to and from the power amplifier of the 6000A are disconnected. In this
mode, the 6000A functions as a stand-alone pre-amplifier. The pre-amplifier section
of the 6000A can be connected to a stereo power amplifier, or to two mono-block
amplifiers.
Integrated mode
The pre-amplifier section is internally connected to the power amplifier, Pre-amplifier output is also
operational in this mode. A second power amplifier can be connected for bi-amplification as shown
in the diagram.
Important Safety
Information
Getting Started
Controls and Connectors
Remote Handset Connections Operation Warranty Coverage Specifications
To Next Page
Loading...
Need help?
General
