EasyManuals Logo

Audiovox VME 9425 User Manual

Audiovox VME 9425
Go to English
192 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #78 background imageLoading...
Page #78 background image
78
System Reset
To correct a system halt or other illegal operation, use the tip of a pen to press the reset
button located on the front bottom-left corner of the unit behind the protective cover. After a
system reset, the unit restores all factory default settings.
NOTE: If the unit is reset while a DVD is playing, the DVD resumes play once the reset
is complete.
Image/Display Settings
Video Output Modes
The following table shows the video output mode for each playing source.
Video Output Modes
Playing Source Video Output Modes
AM/FM TUNER RGB Mode
DVD YCbCr Mode
AUX IN CVBS Mode
*CVBS – Composite Video Baseband Signal
Picture Adjustment
To adjust monitor display settings, perform the following steps:
1. Press and hold the NAV button on the monitor to display the picture adjustment menu.
The “BRIGHT” bar is highlighted in yellow.
2. Turn the rotary encoder to adjust the brightness setting level.
3. Press and hold the NAV button again. The “CONTRAST” bar is highlighted in yellow.
4. Turn the rotary encoder to adjust the contrast setting level.
5. Press and hold the NAV button again to exit the picture adjustment menu.
Parking Brake Inhibit
When the pink “Parking” wire is connected to the vehicle Parking Brake circuit, the front
TFT monitor will display video when the Parking Brake is engaged. (When the pink wire is
grounded via the Parking Brake circuit, video will be displayed.)

Table of Contents

Other manuals for Audiovox VME 9425

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Audiovox VME 9425 and is the answer not in the manual?

Audiovox VME 9425 Specifications

General IconGeneral
BrandAudiovox
ModelVME 9425
CategoryCar Receiver
LanguageEnglish

Related product manuals