20
1. Turn the bit Ten D on.
2. Connect the USB cable to the appropriate port on the bit Ten D and to an available USB slot on the PC.
WARNING When connecting a PC laptop via USB cable to the bit Ten D while the device is turned on, the laptop
has to work with its own battery and stay disconnected from the mains adapter (external power supply).
Once the connection between the PC laptop and the bit Ten D is established, you can immediately connect
the computer, if necessary, to the mains adapter.
3. Windows XP: the PC will recognize the bit Ten D interface and will automatically install the driver;
Windows XP Windows XP
Windows Vista: the PC will recognize the bit Ten D interface and will automatically install the driver;
Windows Vista Windows Vista
Windows 7: the PC will recognize the bit Ten D interface and will automatically install the driver;
Windows 7 Windows 7
4. The peripheral device has been installed correctly and is ready for use.
7.2 DRIVERS INSTALLATION GUIDE
Remark:
The bit Ten D uses HID drivers already integrated in Windows. For this reason, they are not included on the
CD and will always install automatically.
7
8. Windows XP: complete the installation procedure, then click CLOSE to exit the installation;
Windows Vista: complete the installation procedure, then click CLOSE to exit the installation;
Windows 7: complete the installation procedure, then click CLOSE to exit the installation:
Windows 8: go on and complete the installation procedure, then click on CLOSE to exit the installation;
To Next Page
Loading...
Need help?
General
