To Next Page

To Previous Page

ADVANCED MANUAL / bit Ten D /

9. TROUBLESHOOTING

1. bit Ten D functioning problems

- If, while tuning the system with a laptop PC, the bit Ten D shows some problems functioning, try to disconnect

the laptop PC power supply cable. This way, with the laptop PC working on battery power, you avoid a

possible voltage difference in USB ground between car ground (bit Ten D) and earth (PC).

2. The bit Ten D does not connect to the PC software

- If, while tuning the system with a laptop PC, the bit Ten D is switched off and then on again, the connection

is lost and the software can not “finalize” the selected setup. If you don’t want to lose the modifications and

setup previously selected, proceed as per the following steps:

a- save the setup as a file on the PC using the function FILE / SAVE SETUP;

b- exit the software;

c- turn on the bit Ten D;

d- launch the software again;

e- load the setup file again using the function FILE / LOAD SETUP.

3. The bit Ten D does not respond

If, while tuning the system with a laptop PC, the bit Ten D does not respond, proceed as per the following steps:

a- turn the bit Ten D off with the DRC knob, disconnect the Remote IN, or disconnect the power supply cable

for a few seconds;

b- save the setup as a file on the PC using the function FILE / SAVE SETUP;

c- exit the software;

d- turn on the bit Ten D;

e- launch the software again;

f- load the setup file again using the function FILE / LOAD SETUP.

4. Settings not stored

In order to successfully complete the bit Ten D setup and not lose the work done, remember to store the

selected settings. Select File from the main software menu via the PC and then choose Finalize to bit Ten D.

Loud whistle / background hiss.

In case a loud whistle / background hiss can be heard, it may be necessary to repeat the input sensitivity setup and /

or to rectify the output levels adjustment. For more information,

see sections 8.1.2 - 8.1.13 in this manual.

In case product UPGRADES are available online, proceed as follows:

- Save the previous setup (in case you want to open it in OFFLINE mode);

- Unplug the bit Ten D RCA plugs to the amplifiers.

- Restart the bit Ten D PC software and select TARGET mode.

Select FILE from the PC main software menu and

then choose Check for Updates.

9.1 SYNCHRONIZATION WITH A PC

9.3 FIRMWARE UPGRADE

9.2 BACKGROUND NOISE

Audison bit Ten D User Manual

Questions and Answers: