Audison LRX6SR - Subsonic Filter Cut-Off Frequency Modification; VCA-VCA1 D Modules Insertion

31
SETTING PANEL
SUBSONIC FILTER CUT-OFF FREQUENCY MODIFICATION
Replace FS1, FS2, FS3, FS4 resistors according to
the values in the setting panel table.
Remark: Cut the new resistors
rheophores according to the
size in the picture.
Procedure:
VCA-VCA1D MODULES INSERTION
LRx 6.SR Direct can accept one of the two optional kits which allow the subwoofer volume remote
control: VCRAK or VCRDK.
These kits have a specific module,VCA or VCA1D, to insert into the amplifier through the setting panel.
Installation:
1 - Remove BYP12 bridge.
2 - Insert VCA/VCA1D module.
- Insertion key. It prevents the module from
being inserted in the wrong way.
Subsonic filter is pre-adjusted at 20 Hz. In order to modify this value, please act according to what
follows.
Man. LRx 6.SR in 4 Lingue 10-02-2004 16:56 Pagina 31