AUMA ACE C 01.2 Profinet Series - Page 35

Behaviour
≙ Operation direction/posi-
tion
Value
Position 10 is approached in clockwise direction
(CW).
CW Position 10
0x9A
Position 11 is approached in clockwise direction
(CW).
CW Position 11
0x9B
Position 12 is approached in clockwise direction
(CW).
CW Position 12
0x9C
Position 13 is approached in clockwise direction
(CW).
CW Position 13
0x9D
Position 14 is approached in clockwise direction
(CW).
CW Position 14
0x9E
Position 15 is approached in clockwise direction
(CW).
CW Position 15
0x9F
Position 16 is approached in clockwise direction
(CW).
CW Position 16
0xB0
Actuator operation in counterclockwise direction
(without stop at any position).
CCW
0xA0
Position 1 is approached in counterclockwise direc-
tion (CCW).
CCW Position 1
0xA1
Position 2 is approached in counterclockwise direc-
tion (CCW).
CCW Position 2
0xA2
Position 3 is approached in counterclockwise direc-
tion (CCW).
CCW Position 3
0xA3
Position 4 is approached in counterclockwise direc-
tion (CCW).
CCW Position 4
0xA4
Position 5 is approached in counterclockwise direc-
tion (CCW).
CCW Position 5
0xA5
Position 6 is approached in counterclockwise direc-
tion (CCW).
CCW Position 6
0xA6
Position 7 is approached in counterclockwise direc-
tion (CCW).
CCW Position 7
0xA7
Position 8 is approached in counterclockwise direc-
tion (CCW).
CCW Position 8
0xA8
Position 9 is approached in counterclockwise direc-
tion (CCW).
CCW Position 9
0xA9
Position 10 is approached in counterclockwise dir-
ection (CCW).
CCW Position 10
0xAA
Position 11 is approached in counterclockwise dir-
ection (CCW).
CCW Position 11
0xAB
Position 12 is approached in counterclockwise dir-
ection (CCW).
CCW Position 12
0xAC
Position 13 is approached in counterclockwise dir-
ection (CCW).
CCW Position 13
0xAD
Position 14 is approached in counterclockwise dir-
ection (CCW).
CCW Position 14
0xAE
Position 15 is approached in counterclockwise dir-
ection (CCW).
CCW Position 15
0xAF
Position 16 is approached in counterclockwise dir-
ection (CCW).
CCW Position 16
0xC0
Byte 7: Digital outputs 1
The digital outputs Fieldbus DOUT 1 – DOUT 6 of the fieldbus interface can be used
as commands for the output contacts. For this, the outputs of the output contacts
have to be assigned with the signals Fieldbus DOUT 1 – Fieldbus DOUT 6.
35
Actuator controls
AC 01.2/ACExC 01.2 Profinet Description of the data interface