2
Actuator controls AUMA MATIC AM/ AMExB/ AMExC
Profibus DP Short instructions bus connection
Scope of these instructions
These instructions are valid for multi-turn actuators of type ranges
SA(R) 07.1 – SA(R) 16.1 and SA(R)ExC 07.1 – SA(R)ExC 16.1 and for
part-turn actuators of type ranges
SG(R) 05.1 – SG(R) 12.1 and SGExC 05.1 – SGExC 12.1
Table of contents Page
1. Safety instructions 3
1.1 Range of application 3
1.2 Commissioning (electrical connection) 3
1.3 Maintenance 3
1.4 Warnings and notes 3
2. Short description 3
3. Electrical connection 4
3.1 Power supply (standard) 4
3.2 Bus connection (standard) 5
3.3 Fitting the cover 6
3.4 Remote position transmitter 7
3.5 AUMA MATIC on wall bracket 7
3.6 Test run 7
3.7 Mains and bus connection for Ex-version with plug/ socket connector/ terminal board (KP) 8
3.8 Mains and bus connection for Ex-version with plug-in terminal connection (KES) 10
3.9 Redundant bus connection 11
3.10 Bus cables 12
3.11 Setting the Profibus DP address 13
4. Description Profibus DP interface 14
4.1 Assignment of the customer inputs of the Profibus DP interface (option) 15
4.2 Assignment Profibus DP connection 16
4.3 Assignment positioner connections 16
4.4 Checking/ setting the switches on the logic board 17
5. Appendix A Literature references 18
6. Appendix B Connecting the cable shield for the AUMA MATIC AMExB/ AMExC 01.1 18
Index 19
Addresses of AUMA offices and representatives 20
To Next Page
Loading...
