AUMA SQEx 12.2 User Manual

376.4.4. Terminal compartment: close
386.5. KES electrical connection
396.5.1. Terminal compartment: open
406.5.2. Cable connection
416.5.3. Fieldbus cables: connect
426.5.4. Terminal compartment: close
426.6. External earth connection
436.7. Accessories for electrical connection
436.7.1. Actuator controls on wall bracket
446.7.2. Parking frame
457. Operation................................................................................................................................
457.1. Manual operation
457.1.1. Manual valve operation
457.2. Motor operation
457.2.1. Operating the actuator from local controls
467.2.2. Actuator operation from remote
477.3. Menu navigation via push buttons (for settings and indications)
487.3.1. Menu layout and navigation
497.4. User level, password
497.4.1. Password entry
507.4.2. Password change
507.4.3. Timeout for incorrect password entry
517.5. Language in the display
517.5.1. Language change
528. Indications..............................................................................................................................
528.1. Indications during commissioning
528.2. Indications in the display
538.2.1. Feedback signals from actuator and valve
558.2.2. Status indications according to AUMA classification
568.2.3. Status indications according to NAMUR recommendation
588.3. Indication lights of local controls
588.4. Mechanical position indication (self-adjusting)
598.5. Mechanical position indication via indicator mark (not self-adjusting)
609. Signals (output signals).........................................................................................................
609.1. Signals via Modbus RTU
609.2. Status signals via output contacts (digital outputs)
609.2.1. Assignment of outputs
609.2.2. Coding the outputs
619.3. Analogue signals (analogue outputs)
6210. Commissioning (basic settings)...........................................................................................
6210.1. End stops in part-turn actuator
6310.1.1. Set end stop CLOSED
6310.1.2. Set end stop OPEN
6410.2. Type of seating: set
6510.3. Torque switching: set
6710.4. Limit switching: set
6810.5. Fieldbus address (slave address): set
6910.6. Test run
7010.6.1. Direction of rotation at mechanical position indicator: check
3
SQEx 05.2 – SQEx 14.2/SQREx 05.2 – SQREx 14.2 Control unit: electronic (MWG)
ACExC 01.2 Non-Intrusive Profibus DP Table of contents

AUMA SQEx 12.2 Specifications

General

Brand	AUMA
Model	SQEx 12.2
Category	Controller
Language	English