7010.6.2. Limit switching: check
7211. Commissioning (settings in the actuator)...........................................................................
7311.1. Switch compartment: open/close
7311.2. Mechanical position indicator (self-adjusting)
7411.2.1. Mechanical position indicator: set
7411.2.2. Gear stage of the reduction gearing: test/set
7511.3. Mechanical position indication via indicator mark (not self-adjusting)
7611.3.1. Mechanical position indicator: set
7611.3.2. Gear stage of the reduction gearing: test/set
7812. Corrective action....................................................................................................................
7812.1. Faults during commissioning
7812.2. Fault indications and warning indications
8212.3. Fuses
8212.3.1. Fuses within the actuator controls
8312.3.2. Fuse replacement
8312.3.2.1. Replace fuses F1/F2
8312.3.2.2. Test/replace fuses F3/F4
8412.3.3. Motor protection (thermal monitoring)
8513. Servicing and maintenance...................................................................................................
8513.1. Preventive measures for servicing and safe operation
8513.2. Disconnection from the mains
8613.2.1. Disconnection from the mains with KT/KM electrical connection
8713.2.2. Disconnection from the mains with KP/KPH and KES electrical connection
8713.3. Maintenance
8813.4. Disposal and recycling
9014. Technical data.........................................................................................................................
9014.1. Technical data Part-turn actuator
9214.2. Technical data Actuator controls
9814.3. Tightening torques for screws
9915. Spare parts.............................................................................................................................
9915.1. Part-turn actuators SQEx 05.2 – SQEx 14.2/SQREx 05.2 – SQREx 14.2 KT/KM
10115.2. Actuator controls ACExC 01.2 KT/KM
10315.3. Actuator controls ACExC 01.2 KP/KPH
10515.4. Actuator controls AUMATIC ACExC 01.2 KES
109Index........................................................................................................................................
4
SQEx 05.2 – SQEx 14.2/SQREx 05.2 – SQREx 14.2 Control unit: electronic (MWG)
Table of contents ACExC 01.2 Non-Intrusive Profibus DP