AUMA TIGRON TR-M30X Short Instructions

AUMA TIGRON TR-M30X

10 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

Multi-turn actuators

TIGRON

TR-M30X – TR-M1000X

Modbus RTU

Use short instructions in combination with operation instructions only!

These short instructions are only complete with the respective operation instructions of the

actuator. Safety and warning instructions contained in the actuator operation instructions must

be heeded when performing work on the actuator!

Fieldbus connectionShort instructions

Table of Contents

Other manuals for AUMA TIGRON TR-M30X

Manual132 pages

Operation Instructions76 pages

Questions and Answers:

B
Bradley SmithAug 12, 2025
Why is there no communication between slave and master in my AUMA TIGRON TR-M30X Controller?
- H
  hessjulieAug 12, 2025
  If the AUMA Controller isn't communicating between slave and master, it might be due to incorrect parameter data. To resolve this, correct the parameter data in the master. Alternatively, the parameters might not have been sent yet, so ensure you send them. Also, verify the GSD file is correct. Finally, check the cable connection to ensure it's not interrupted and the polarity is correct.
A
Andrew BrownAug 19, 2025
What to do if there is no communication between slave and master in AUMA Controller?
- J
  James HintonAug 19, 2025
  If the AUMA Controller isn't communicating between slave and master, it might be due to incorrect configuration data. Correct the configuration in the master. Ensure that you send configuration data.
T
Tiffany HarveyAug 27, 2025
What to do if AUMA Controller slave is in the fail safe state?
- K
  Kyle WallaceAug 27, 2025
  If the AUMA Controller slave is in a fail-safe state, check all other implemented slaves at the Profibus. If necessary, deactivate the Autoclear function in the master. You may also need to send a GC OPERATE telegram.
H
Heather BoothSep 3, 2025
What to do if master does not send an operation command to AUMA TIGRON TR-M30X Controller?
- R
  Rose WalkerSep 3, 2025
  If the master isn't sending an operation command to the AUMA Controller, check the program of controls.

AUMA TIGRON TR-M30X Specifications

General

Protection class	IP68
Type	TR-M30X
Operating temperature	-30 °C ... +70 °C
Ambient Temperature	-30 °C ... +70 °C
Housing Material	Aluminium
Voltage	24 V DC

Related product manuals

Preview: AUMA SA 07.2

Preview: AUMA ACV 01.2

Preview: AUMA SA Series

Preview: AUMA SQEx 05.2

Preview: AUMA SAEx Series

AUMA SAEx Series