Auriol 4-LD6544 - Setup; Putting Outdoor Sensor into Operation; Putting the Pool Sensor into Operation; Putting the Base Station into Operation

- 16 -
Setup
Remove all packaging material from the product.
Remove all protective films before using for the first time.
Note: First insert the batteries into the outdoor and pool sensors.
Putting outdoor sensor into operation
• Open the battery compartment of the outdoor sensor by sliding the battery
compartment cover in the direction of the arrow.
• If necessary, remove the old batteries first.
• Insert the supplied batteries 2 x 1.5 V AAA R03/LR03 in the correct polarity (+/-).
• The control LED lights up temporarily and the outside temperature is di-
splayed.
• Close the battery compartment of the outdoor sensor
.
Putting the pool sensor into operation
• Open the battery compartment of the pool sensor
by unscrewing the funnel
cover and sliding the battery compartment cover in the direction of the
arrow.
• If necessary, remove the old batteries first.
• Insert the supplied batteries 2 x 1.5 V AA R6/LR6 in the correct polarity (+/-).
• The display is briefly shown completely and the water temperature is shown.
• Close the battery compartment of the pool sensor and tighten the funnel cover
again.
Putting the base station into operation
• Open the base station‘s battery compartment
.
• If necessary, remove the old batteries first.
• Insert the supplied batteries 2 x 1.5 V AA R6/LR6 in the correct polarity (+/-).
• The display is briefly shown completely and a signal tone sounds. The indoor tem-
perature and indoor humidity are then displayed.
• Close the battery compartment of the base station .
Note: It may take a few minutes for the product to adjust to the environmental condi-
tions and display the correct values.