- 18 -
if necessary.
Switch radio signal reception off and on
You can switch off the radio reception permanently.
• Press and hold the +|MEM/RF button
and the -| RCC button simulta-
neously for a few seconds until only the waves of the radio symbol are per-
manently displayed. The base station is now no longer searching for and receiving
the DCF77 radio signal.
You can turn on the radio reception again.
• Press and hold the +|MEM/RF button and the -| RCC button again at the
same time for a few seconds until the radio symbol disappears completely. The
base station can receive the DCF77 radio signal again.
Restart/stop radio signal reception
You can manually restart the radio signal reception.
• Press and hold the -| RCC
button for a few seconds until the radio symbol
flashes. The base station searches for and receives the DCF77 radio signal. If the
reception is successful, the radio symbol appears permanently and the correct
time , date and day of the week are automatically set.
You can stop the radio signal reception.
• While receiving the radio signal (radio symbol flashes), press and hold the
-| RCC button for a few seconds. The radio symbol disappears and the
radio signal reception is terminated.
Manually adjust outdoor/pool sensor
• Open the battery compartment
of the outdoor sensor.
• Unscrew the funnel cover of the pool sensor and remove it.
• Press and hold the +|MEM/RF button on the base station, the icon will
flash in each reception area OUT and POOL TEMP.
• In addition, press the TX button on the outdoor sensor and/or the TX button
on the pool sensor to transfer the measurement data from the sensors to the
main station. The red control led / lights up briefly.
• Tighten the funnel cover again.
To Next Page
Loading...
