AFW 2 A1
GB
│
IE
│
NI
│
13 ■
Once the power supply has been established, the display will
light up and go through a brief check of the display elements.
The weather station will now attempt to connect to the outdoor
sensor. The reception symbol
flashes on the outdoor tempera-
ture panel 3.
NOTE
If no outdoor temperature is displayed within around 3 minutes,
the weather station will stop the reception search. The reception
symbol
goes out and and are displayed on the
outdoor temperature panel 3.
It is possible that no signal can be received due to the sur-
rounding buildings or because the distance is too great.
If you are unable to establish an automatic connection to the
outdoor sensor, you can do this manually:
♦ Press and hold the –/CH button 6 until the reception
signal
flashes on the outdoor temperature panel 3.
♦ Press the TX button o to initiate the outdoor sensor
radio signal manually.
The weather station automatically starts to receive the MSF
signal after 3 minutes irrespective of whether the outdoor sensor
reception search has been successful or not. The reception
symbol
flashes on the time panel 5.
If the reception symbol is not flashing completely ( ) on the
display, this means that the reception of the MSF signal is too
weak and the time cannot be synchronised. Try to find a set-up
location in which the reception symbol flashes completely ( )
on the display.
To Next Page
Loading...
