AFW 2 A1
■ 22
│
GB
│
IE
│
NI
♦ In basic mode, if you press the +/MEM button 7 the
symbol is shown and the lowest measured value for indoors
and outdoors is displayed.
♦ After around 5 seconds, the current values for indoors and
outdoors will automatically be displayed.
♦ Press and hold the +/MEM button 7 for around
3 seconds
to delete the saved values.
Background lighting
The background lighting on the display switches off after around
10 seconds during battery operation to save the batteries.
♦ Press the SNOOZE/LIGHT button 9 to switch the display
background lighting on for around 10 seconds.
The display background lighting is permanently switched on
when the device is powered by the mains.
♦ Press the SNOOZE/LIGHT button 9 again to set the
background lighting brightness in four stages (high,
medium, low, off).
Battery display
If the battery symbol is shown on the indoor temperature
panel 2 the batteries in the weather station should be replaced
as soon as possible (see also the section Operating the weather
station).
If the battery symbol
is shown on the outdoor temperature
panel 3 the batteries in the outdoor sensor should be replaced
as soon as possible (see also section Operating the outdoor
sensor).
To Next Page
Loading...
