AUTEC - Air series
General operating instructions 15
LILK1E00-01
6.2 Command activation
When the radio remote control is started, it is possible to move the pushbuttons and switches
corresponding to the command you want to perform.
The user must be properly trained about the symbols on the transmitting unit panel, to be
aware of the matching between actuators and movements on the machine (symbols used are
denedbythemachinemanufactureraccordingtothefunctionsofthemachine).
6.3 Data Feedback Function
The user receives information and/or signals concerning the controlled machine by means
of the Data Feedback function.
During normal radio remote control operation, pay particular attention to the indications
displayed and signalled by the display or through the LEDs: they can be helpful to evaluate
the machine working status.
Any information shown and signalled on the display or through the LEDs
can never be considered or used as a safety signal or for legal metrology.
When operating and moving the machine, remember that the radio remote
control does not intervene autonomously when potential hazardous situations
are displayed and signalled.
6.3.1 Operation with display
If the transmitting unit has a display, it is possible to show signal icons, measurements
collected from the machine and their description.
The machine manufacturer chooses which information are displayed and the way they are
displayed (icons and/or measurements and/or descriptions).
6.3.2 Operation with LED
IfthetransmittingunithasanLEDarray,specicmachineconditionsaresignalledifthey
are on (i.e. load limits, limit switch, …).
The signalled conditions depend on the settings chosen by the machine manufacturer.
To Next Page
Loading...
Need help?
General
