AUTEC LK NEO 10 DF Original Instructions

AUTEC - Air series
Operation 17
LILK1E00-01
7 Operation
7.1 Battery
The Air series' transmitting units can only be powered by Autec rechargeable
batteries.
For any warnings and instructions regarding the battery, see "Part E" in
the manual.
7.1.1 Battery insertion
Push the battery towards the contacts on the transmitting unit and insert it inside the housing.
The battery slides easily into place and ensures that the positive (+) and negative
(-) poles are correctly connected only if it is inserted with the plate facing its
housing,sothatthebattery'scontactsmatchthetransmittingunit'scontacts.
7.1.2 Battery removal
Push the battery towards the contacts on the transmitting unit and remove it from the housing.
When the transmitting unit is not in use, remove the battery if possible.
7.1.3 Battery run time indicator
LK NEO 10 and LK NEO 12 transmitting units
Perform the following procedure to check the run time of the battery in the LK NEO 10 and
LK NEO 12 transmitting units:
1. switcho󰘯thetransmittingunitandunlocktheSTOPpushbutton
2. activate command S1 (check in the technical data sheet which actuator it corresponds
to) and press the START pushbutton until LED 1, LED 2 and LED 3 (indicating battery
level) illuminate:
- 1 LED on: low level
- 2 LEDs on: medium level
- 3 LEDs on: maximum level.
Run time indication disappears after some seconds.
LK NEO 10 DF transmitting unit
See paragraph 5.2.2 to check the run time of the battery in the LK NEO 10 DF transmitting unit.

AUTEC LK NEO 10 DF Specifications

General

Brand	AUTEC
Model	LK NEO 10 DF
Category	Transmitter
Language	English