AUTEC - Air series
Malfunction signalled by the transmitting unit 25
LILK1E00-01
8 Malfunction signalled by the transmitting unit
Use the light signals on the transmitting unit to identify the radio remote control malfunction.
If the problem persists after the suggested solution has been carried out, contact the support
service of the machine manufacturer.
Signals Possible reason Solutions
The green LED is steady
on.
The transmitting and
receiving unit do not
communicate.
Start up the radio remote control. If the
radio remote control does not start up,
check that the receiving unit is powered
on.
The green LED blinks
fast.
Temporary loss of radio
link.
Bring the actuators corresponding
to movement commands to the
rest position and press the START
pushbutton until the green LED blinks
slowly.
The green LED blinks
slowly
(one blink per second).
The receiving unit may
not work correctly.
See "Receiving unit signals" in Part D of
the manual.
The red LED is steady
on during start up
The STOP pushbutton is
pressed or damaged.
Unlock the STOP pushbutton or contact
the support service.
The red LED blinks
twice per second during
start up.
At least one of the
commands that were
checked at start-up is
enabled or damaged (see
technical data sheet).
Bring the actuators corresponding to the
commands checked during start up to
the rest position or contact the support
service.
The red LED blinks
three times per second
during start up.
Thebatteryisat. Replace the battery with a charged one.
The red LED is steady
on for two seconds.
The transmitting unit does
not work correctly.
Contact the support service.