AUTEC LK NEO 10 DF Original Instructions

26
LILK1E00-01
Malfunction signalled by the transmitting unit
AUTEC - Air series
Signals Possible reason Solutions
The green and red LEDs
are steady on during
start up.
A wrong "Key ID 0-1" or
"ID internal tx memory"
has been inserted in the
transmitting unit.
Use the correct "Key ID 0-1" or "ID
internal tx memory".
You'reusinga"BACK-
UP UNIT" with the "Key
ID 0-1" or "ID internal
tx memory" of the
transmitting unit that has
been replaced.
Store the address in the "BACK-UP
UNIT" (see paragraph 7.3.5).
The green and red LEDs
blink three times per
second during start up.
The "Key ID 0-1" or the
"ID internal tx memory" is
damaged.
Contact the support service.
The green LED blinks
and the red LED is
steady on during start
up.
The procedure
corresponding to the
UNPAIR submenu and
given in the document
"Menu of Transmitting
Unit (MTU)" has been
carried out.
Perform the ALIGNMENT procedure.

AUTEC LK NEO 10 DF Specifications

General

Brand	AUTEC
Model	LK NEO 10 DF
Category	Transmitter
Language	English