AUTEC LK NEO 10 DF User Manual

8.9 Zero-G sensor
The Transmitting Unit is equipped with a Zero-G sensor only upon request
of the Machine Manufacturer and/or of the Installer, who are responsible for
the decision on the conditions for the Zero-G sensor to activate.
The Zero-G sensor can activate for one or more of the following causes:
- Impact: the Zero-G sensor activates when the Transmitting Unit impacts with at least a
30-centimetre movement and with an acceleration higher than 2g.
- Fall: the Zero-G sensor activates when the Transmitting Unit falls from higher than 1 meter.
- Tilt: the Zero-G sensor activates when the Transmitting Unit is tilted for more than one
second by a de󰘰ned angle with respect to the ground. The value of the tilting angle is set
by Autec, but it is decided by the Machine Manufacturer and/or by the Installer (possible
options: 45°/60°/90°).
The Zero-G sensor may also activate if the Transmitting Unit is thrown or is rolling. In this
case the Zero-G sensor activates due to the 󰘰rst detected event among the above-mentioned
ones (impact, fall, tilt).
Autec sets the system so that when the Zero-G sensor activates, one of the following
behavior occur:
- the Transmitting Unit switches o󰘯,
- all the Radio Remote Control's commands are deactivated, except one particular Machine
function, which is activated at the same time (e.g. horn).
The Machine Manufacturer and/or the Installer have the responsibility to
decide the behaviour of the Zero-G sensor. Before using the Machine, the
User must be aware of the expected behaviour and make sure that it works
correctly.
8.10 Vibration alarm
The LK NEO 10 DF Transmitting Unit (Model LKN Type DA2FM) can be equipped with the
"Vibration alarm".
The "Vibration alarm" activates the Transmitting Unit's vibration if speci󰘰c signals coming
from the Machine are shown on the display.
The Transmitting Unit's vibration aims at drawing the User's attention to the corresponding
signal shown on the display.
The Transmitting Unit can be equipped with the "Vibration alarm" upon request of the Machine
Manufacturer and/or the Installer.
The Machine Manufacturer and/or the Installer decide which signals shown
in the display must cause the vibration of the Transmitting Unit.
34
LIULK1ES0_eng-01
General operating instructions
AUTEC - Air series

AUTEC LK NEO 10 DF Specifications

General

Brand	AUTEC
Model	LK NEO 10 DF
Category	Transmitter
Language	English