8.16 "Data Feedback" function
The "Data Feedback" function acts through the LED array or the display. The User receives
information and/or signals concerning some particular situations and the movements of the
controlled Machine by means of this function.
During normal Radio Remote Control operation, pay particular attention to the indications
displayed and signalled by the display or through the LEDs: they can be helpful to evaluate
the Machine working status.
Any information shown and signalled on the display and/or through the
"Data Feedback" LEDs can never be considered or used as a safety signal
or for legal metrology.
When operating and moving the Machine, remember that the Radio Remote
Control does not operate autonomously when potential hazardous situations
are displayed and signalled.
If the green LED repeats the sequence "three blinks and a pause", there is no
information and/or signals coming from the "Data Feedback" function. In this
case, bring the Transmitting Unit closer to the Receiving Unit until the green
LED blinks slowly.
8.16.1 Operation with display
If the Transmitting Unit has a display, it is possible to show warning icons, the measurements
collected from the Machine and their description.
The Machine Manufacturer chooses which information are displayed and the way they are
displayed (icons and/or measurements and/or descriptions).
8.16.2 Operation with LED
If the Transmitting Unit has an LED array for the "Data Feedback" function, specic Machine
conditions are signalled if they are illuminated (by way of example: load limits, limit switch).
The signalled conditions depend on the settings chosen by the Machine Manufacturer.
40
LIULK1ES0_eng-01
General operating instructions
AUTEC - Air series
To Next Page
Loading...
Need help?
General
