7 Maintenance
- 24 -
LIMM&SA0-00.fm
comments) showing that this check has been regularly carried out. Keep the record together
with other installation documents.
External
electrical
conductors
Every twelve months:
1.make sure that the cable which connects the receiving unit to the machine is intact along the
full length
2.make sure that the connecting plugs and sockets are intact and connected
3.check the strips or other fixing systems and replace them if necessary
4.make sure that the connecting cable is not damaged, particularly at the cable glands
7.2 Special maintenance
Special maintenance consists of operations carried out in order to restore use and
working conditions foreseen when the product is placed on the market; this happens
through non-programmed replacement of damaged or worn out parts or components
with original parts or components.
Always ensure that the receiving unit has been disconnected from the power
source and that the battery has been removed from the transmitting unit before
carrying out any special maintenance work.
Any fault should be repaired by authorised personnel (contact Service), using
original Autec spare parts only.
The following radio remote control data must be communicated in order to make interventions
faster and more reliable:
- serial number
-purchase date (given on the certificate of guarantee)
- description of the problem found
- address and telephone number of the place where the device is being used (with the name of
the person to contact)
- local supplier.
It is recommended to read and understand all parts of this manual, and make sure that
all the instructions it contains have been followed correctly before contacting the Ser-
vice Technicians.
7.3 Disposal
When disposing of a radio remote control, give it to the waste separate collecting services in the
user's country.
Please pay particular attention when recycling the batteries, applying local rules. Do not throw
them away with domestic trash.
To Next Page
Loading...
Need help?
General
