AUTEC Modular series User Manual

- 1 -
LIMM&SA0-00.fm
INDEX
1 Introduction ...................................................................................... 2
1.1 Conventions.........................................................................................2
1.2 System description ...............................................................................2
1.3 Conformity ..........................................................................................4
1.4 Risk analysis........................................................................................5
1.5 Documentation.....................................................................................5
1.6 Modular Series technical data.................................................................6
1.7 Frequencies.........................................................................................6
2 Transmitting units ............................................................................. 7
2.1 Description of MK12 and MK10...............................................................7
2.2 Description of MJ..................................................................................8
2.3 Warnings for the use of the transmitting units..........................................9
2.4 Warnings for the maintenance of the transmitting units ............................. 9
3 Receiving unit .................................................................................. 10
3.1 Description of the receiving unit ........................................................... 10
3.2 Inner parts of the “Master/Slave” receiving units .................................... 11
3.3 Inner parts of the “Master/Master” receiving units................................... 12
3.4 General warnings for the installation of the receiving unit ........................ 12
3.5 Specific warnings for the installation of the receiving unit......................... 14
3.6 Warnings for the maintenance of the receiving unit................................. 14
3.7 External signal lights of the receiving unit.............................................. 15
3.8 Internal signal lights of the receiving unit .............................................. 16
4 Operating mode of “Master/Slave” .................................................. 17
4.1 Command “Take/Release 2” or “Release 2”............................................ 17
4.2 Power on and start up......................................................................... 18
5 Operating mode of “Master/Master”................................................ 19
5.1 Command “Take/Release” ................................................................... 19
5.2 Power on and start up......................................................................... 20
6 Operating mode of the transmitting units ........................................ 21
6.1 Command activation ........................................................................... 21
6.2 STOP................................................................................................ 22
6.3 Battery ............................................................................................. 22
6.4 Signals.............................................................................................. 22
6.5 Switching off...................................................................................... 22
7 Maintenance .................................................................................... 23
7.1 Routine maintenance .......................................................................... 23
7.2 Special maintenance........................................................................... 24
7.3 Disposal............................................................................................ 24
8 Programming ................................................................................... 25
8.1 Programming the transmitting module................................................... 25
8.2 Programming the receiving module....................................................... 26
8.3 Programming the master board E16B14AC............................................. 27
8.4 Programming the bus board E16RI02_ .................................................. 27
8.5 Frequency tables................................................................................ 27
9 Diagnostics ...................................................................................... 28
9.1 Transmitting unit diagnostics ............................................................... 28
9.2 Receiving unit diagnostics.................................................................... 29

AUTEC Modular series Specifications

General

Brand	AUTEC
Model	Modular series
Category	Remote Control
Language	English